The new generation MD-7 Telescope adopts multiple innovative technologies. The traditional test distances of 4.6 meters and 10.67 meters have been replaced by virtual image simulation. This achieved equivalent test results at extremely short distances. 

Unique virtual optical path system

The simulated optical path system replaces the traditional 4.6-meter measurement distance while perfectly compatible with the 10.67-meter sight distance of the American standard Z87.1.   

2000dpi LCD Target

the MD-7 has a built-in LCD display screen with changeable target

Its clarity is nearly 10 times higher than the traditional retina screen

550 nm green light by ISO standard to display content of target , reducing dispersion further affecting testing accuracy

Powerful MD software 

60% of sceen shown for target and 40% for measurement result

Intuitive interface showing measurement data for single eye or binocular eye

Supports quick sample selection, sample entry, clarity value entry, report export, and etc.

Intelligent assistance for toric sample

During usage of traditional telescope, if the sample has large astigmatism (cylinder power) , the horizontal and vertical lines are difficult to be adjusted to a clear image. For this reason, it is necessary to manually rotate target angle so that it is aligned with toric angle to obtain accurate data of the D1 and D2 meridians. However, MD-7 unique algorithm can automatically identify the toric angle and rotate the tested target for alignment. 

Fantastic wire control makes operations much easier!

No more difficulites in raising your hand to adjust the focus

No hand tremor affects the accuracy of focusing

No manual focusing causes the telescope to make small deviations and vibrations

Automatic measurement of prism 

The combination of LCD target and software algorithm can obtain the prism of the current sample at once. When the prism power of left and right eyes is measured, Mutual difference of the prism required by the standard is calculated automatically from the horizontal and vertical direction. 

Comprehensive tested sample range and standard

Function:

Data show:  display data on single eye/lens or binocular eye

Focus control mode: Focus of telescope controlled by sync signal

Target display:Dynamic target display (automatic exposure of samples with different transmittance)

Target control: European target with automatic rotation, and other different targets are available

Automatic central calibration:Automatic identification and calibration of center position

Prismatic power test:Support prism test,It can test prismatic power, binocular prism mutual difference

Refractive power report:Simulate target display status (target shift and target shape in different diopters)

Clarity Report: Support real-time image of target copied to the report

Prism report:Support binocular or monocular prism report. binocular prism report includes prism mutual difference

Sample type selection: spectacles, sunglasses, goggles, masks, ski goggles, swimming goggles, welding protection

Standard Test Selection:Automatic selection of corresponding test standards according to sample type

American Standard Test:American Standard Definition and Power Test (Radiation Target and Definition Target)

Canadian Standard test: Canadian Definition Test  (Canadian Target to be purchased optionally)